A few days ago we showed you guys a sneak peek of the new Battle Arms Development forged lowers we’ve all been anxiously waiting for. We all know Battle Arms Development doesn’t cut any corners with their products and knew if they made a lower they would do some awesome stuff with it but didn’t know to what extent until today. B.A.D. has basically controlled all aspects of the manufacturing of these lowers to create what is sure to be one of the highest quality lowers on the market. They know the price is much higher than you probably expected to pay for a forged lower but they weren’t going for the most affordable lower. They wanted to offer the best receiver you can get. Because of the additional time and effort it takes to produce these lowers they are made in smaller batches. Check out the details and pictures below, then be ready to snag one for yourself before they are all gone.
Battle Arms hold themselves to a high standard of quality for everything they make. This is especially true with their lower receivers. The forgings are of the highest quality. They control all factors to make it that way. The roll mark with their new logo is done with a 3D laser engraver that they do in-house. The receiver extension threads are helical. All of the pin holes are reamed rather than drilled. The flared mag well is cut using wire EDM and there is no flashing or rough areas. All of this adds up in time and money spent that gives them a lower receiver that has the quality that is on a Battle Arms Development level.
– Mil-spec dimensions and holes.
– 7075 T6 aluminum.
– Mil-spec type 3 hard anodizing.
– High quality and tested forgings.
– 3D laser engraved roll mark with Battle Arms’ new logo.
– All pin holes are reamed rather than drilled.
– Helical rear receiver extension threads (not drilled and tapped).
– Wire EDM cut flared mag well.
– Selector stops have been removed.
– 45 degree safety selector compatible
Available for purchase now at www.RainierArms.com