I honestly never imagined that I would be telling you guys about some “Cool” buffer tube.  Most buffer tubes are just boring but not the Primary Weapons Systems Enhanced Buffer tube.  The EBT is a one piece design eliminating the need for a castle nut and has two QD attachment points machined into the front of the tube.  Whether you are starting your new Black Rifle build or just looking for a nice upgrade, The PWS Enhanced Buffer Tube is definitely worth taking a look at. Take a minute to look at the additional information and pics below.  You can also go to www.PrimaryWeapons.com.

The PWS Enhanced Buffer Tube is the first major upgrade and improvement to the buffer tube in years!  Unlike the original PWS EBT, this unit is made from impact extruded 6061 aluminum in order to keep the cost down while keeping the quality high.

1. One piece construction eliminating the castle nut and ensuring that when installed, the buffer tube cannot become loose.
2. Attachment system automatically indexes the buffer tube perfectly straight.
3. The bottom of the interior buffer tube extends a lip into the receiver, supporting the bottom rear of the bolt carrier, reducing the carrier tilt present in some piston systems.
4. A dead blow buffer is securely installed in the rear of the buffer tube to reduce carrier speed by an average of 10%, and dramatically reduce felt recoil.
5. Two QD sling swivel attachments are machined into the front of the buffer tube allowing ambidextrous connection of your QD slings.
6. The buffer tube is fluted to allow debris to be pushed out of the way, and a drain hole has been placed in the bottom of the tube, allowing for draining of water when the rifle is parallel to the ground.

The PWS Enhanced Buffer Tube is made to accept Mil-Spec stocks.

 

Wanna be my friend?

| Category $1 - $100, Ambidextrous Stuff, American Made, Buffer Tube, Buttstock